Need Help With Maker of Spoon

PHOTOS REQUIRED - marks + item
Post Reply
Draac
Posts: 12
Joined: Thu May 04, 2017 4:03 pm

Need Help With Maker of Spoon

Post by Draac »

I picked up an old spoon, it has a makers mark of HS with a round symbol to the left of the maker's mark.
The spoon also has an inscription - Mariam Rimember From Your Grandfather Henry Leligman 1776.

Note: not a typo on the word "Rimember".

The bowl shows quite a bit of tip wear on the left side (from use), It was well used. It is a serving spoon size 8 and quarter or so inches long.

Any help with the maker would be appreciated. I have done a lot of research but have not come up with the maker.

I have not figured out how to upload images yet but I will when I learn.

Thank you,
Dave
Draac
Posts: 12
Joined: Thu May 04, 2017 4:03 pm

Re: Need Help With Maker of Spoon

Post by Draac »

Looking at it again, it might be SH with the round symbol to the right. My wife just pointed that out to me.

Dave
dognose
Site Admin
Posts: 59003
Joined: Thu Dec 29, 2005 12:53 pm
Location: England

Re: Need Help With Maker of Spoon

Post by dognose »

Hi Dave,

Welcome to the Forum.

Your question cannot be answered without the required images. The below should help you:

How to Add Images

Posting Requirements

Embedded images get a far greater response than just posting links.

Remember to use the 'Preview' button before submitting your post

For more information see:

http://www.925-1000.com/forum/viewtopic ... 82#p103282

Trev.
Draac
Posts: 12
Joined: Thu May 04, 2017 4:03 pm

Re: Need Help With Maker of Spoon

Post by Draac »

dognose wrote:Hi Dave,

Welcome to the Forum.

Your question cannot be answered without the required images. The below should help you:

How to Add Images

Posting Requirements

Embedded images get a far greater response than just posting links.

Remember to use the 'Preview' button before submitting your post

For more information see:

http://www.925-1000.com/forum/viewtopic ... 82#p103282

Trev.
Thank you, for that information. Also, can you tell me how I go about editing my post once I have my images to post ?

Dave
silvermakersmarks
co-admin
Posts: 1717
Joined: Tue Apr 09, 2013 9:22 am
Location: Hertfordshire, UK
Contact:

Re: Need Help With Maker of Spoon

Post by silvermakersmarks »

There is no facility for editing your own posts; just keep adding Replies. However, if you use the "Preview" button as Trev suggests you will be able to see whether you have got it right before you Submit.

Phil
Draac
Posts: 12
Joined: Thu May 04, 2017 4:03 pm

Re: Need Help With Maker of Spoon

Post by Draac »

silvermakersmarks wrote:There is no facility for editing your own posts; just keep adding Replies. However, if you use the "Preview" button as Trev suggests you will be able to see whether you have got it right before you Submit.

Phil
Thank you Phil.
Draac
Posts: 12
Joined: Thu May 04, 2017 4:03 pm

Re: Need Help With Maker of Spoon

Post by Draac »

I reported it with images, Admin you can delete this thread if you would like to.

Dave
Post Reply

Return to “Coin Silversmiths ~ American pre-1860”